ScaleXtric Digital - Micro Chip A - F1 Digital (C7005) - Reviews

(4.4)

16 reviews

Info

Reviewbucket.co.uk scanned the internet for ScaleXtric Digital - Micro Chip A - F1 Digital (C7005) reviews.
You can find all ScaleXtric Digital - Micro Chip A - F1 Digital (C7005) reviews and ratings on this page.

Read the reviews.

Analysis

For ScaleXtric Digital - Micro Chip A - F1 Digital (C7005), 16 customer reviews collected from 1 e-commerce sites, and the average score is 4.4.

Detailed seller stats;
Amazon has 16 customer reviews and the average score is 4.4. Go to this seller.

Detail

Click to list all products in this category.

Similar Items

8.1.2014

Well packaged. Clear instructions - although the instructions were obviously meant to cover ONLY the formula 1-style cars, with the narrow bodies, whereas I'd bought this for a saloon-bodied car (since I couldn't find anyone selling a C7006 at the time). I had to use a bit of lateral thinking when deciding where to mount it and cut some of the wires to length before soldering. YOU DO HAVE TO BE COMPETENT using a soldering iron to make use of this product. I was VERY pleased when, after the conversion, I put the car on the track and it ran perfectly from the first pull of the throttle!

11.5.2009

The best thing with this Chip "A" is its size. It is very small and will fit in most cars. I went for this over the saloon Chip as it was cheaper there is no difference except the size. I fitted it to a Gotham City Police car which proved slightly more difficult as I had to allow for the wiring to the flashing red lights. It all worked great first time. The Chip is very durable even with my lack of care.

2.9.2016

You need some skills with a soldering iron, and be careful with the slot car choice, its not good with high rpm motors. 18000 or less is fine, and you will probably need to make sure there is a "ferrite man" at the motor side of the wiring. Or at least a ceramic "disc".

12.1.2017

Gives new life to older cars. These are quite simple to fit if you can use a soldering iron. My first car to digitise was a Peugeot 307 WRC four wheel drive. With the motor in the front and a belt drive to the rear axle it's a tight squeeze on these.

31.3.2016

It's a little fiddly to install, but I'd never done soldering before and bought a 25w soldering iron and some solder and managed it fine. The car runs perfectly. I'm going to order another so I can convert another car!

9.12.2011

it is a must for old analogue cars to run on new digital tracks. it is good to the oldies back on the track.this chip is mainly for cars older than 2001 i think and it will require some skill in installing

3.12.2006

this is a nice item for a sport car collector i would not recommend it to kids because it a really delacot car an easy to break but apart from that it a nice car

10.7.2016

A little skill required as soldering needed but very simple to do and make any car from any make with little modifying work on a scalextric digital track