logo

Info


Reviewbucket.co.uk scanned the internet for Minoura SWG-400 reviews.
You can find all Minoura SWG-400 reviews and ratings on this page.

Read the reviews.

Analysis


For Minoura SWG-400, 42 customer reviews collected from 1 e-commerce sites, and the average score is 4.

Detailed seller stats;
Amazon has 42 customer reviews and the average score is 4. Go to this seller.

Similar Items

4.12.2015

Product is exactly as it was advertised and worked great as a solution to an over crowded set of handle bars. Having a CX style bike, I have drop bars but on the tops, there is a set of interrupter break leavers which take up a LOT of valuable bar space for accessories. I resorted to this to mount my light on until I found a different solution that is working a bit better.The ONLY issue I had with this device is that with the sheer amount of cabling on the front of my bike (brifters + interrupter breaks) this device made it hard to position well and mount a light to it without it making a mess of the cabling in its place.I eventually went with a 3rd party product that mounted an accessory mount point to the mount point on most forks for a dyno style light.Worked much better as it was below the mass of cables on my bars and thus I didn't fear my light melting down any cable housings and/or me ripping the light off the mount if the cables got pulled taught for any reason.
Read more..

3.11.2015

Mount is fairly solid. Don't be thrown by the reference to 180 degree rotation, though. The arm basically swivels on a hinge (to effectively raise or lower the accessory bar), but there is no way to rotate the entire mount or arm such that both accessory bar and mounted base bar/tube are parallel. In other words, this mount requires a setup wherein the accessory bar is at a 90 degree angle from the bar/tube to which the mount is affixed. So for example, that might mean mounting this on the handlebar stem in order to have the accessory bar run parallel to the handlebars.

1.6.2019

This is a well engineered piece of kit and solves the problem of ultra endurance cycling with aerobars and a front bag and where do you put your front lights if you have carbon disc forks and no crown mount. This had puzzled me for ages and finding this solution was brilliant. Yes - if you have heavy lights mounted on this then for security it is worth putting a zip tie from the aerobar onto the horizontal mounting bar - job done

31.10.2014

Very versitle and has many position settings. For a 758 mile bike ride, Needed my handlebars clear but also needed to mount light, garmin and bike computer on bike. This did the trick! Just had to retighten bolts several times during the four day event....unit kept moving. But one I learned how to insure positions were solidly in place, worked like a charm!

18.7.2015

Got it just to get my handlebars out of the shot. Works fine, minor adjustments required during the ride to keep the angle consistent (even with the plastic rings included to prevent slipping it's going to slip). Only real complaint is that I wish it were quick-release. As is if you need to take it off while changing a flat you need a hex wrench.

9.9.2015

I got this to free up space on my bars during very long rides, by moving my lights to it. It accomplished that mission fine, I knocked it down to four stars because one of the plastic end caps came up and the company ignored my email to support to try to find a replacement for it.

8.11.2014

Worked great. Mounted two lights to it & it held them securely. Just make sure you tighten up all the bolts before you hit the trail. They aren't all real tight from the factory. It is a little smaller diameter so I had to use a small strip of rubber as a shim.

25.2.2015

I have two of these and they are rock solid great.I use them on the real seat stay to mount the generator / induction coils of my lighting system near my rear wheel on my very differently frame configuration Terra Trike three wheel recumbent.

3.4.2015

I use this on my recumbent Bacchetta Giro 20 to hold a Blinkrim 900 bike light and it works as it should. I was drawn to this one because it has greater adjustment flexibility than others that I have seen. It does the job.

17.7.2018

Good product and quality. Although it didn't last longer than I would like, since it was used for a motorcycle (which was not for its original purpose) it nevertheless served its purpose

16.5.2016

Is a quality product. Holds both my headlight and cellphone (LG G3) easily. Way better than the similar product of the TerraTrike brand.

13.4.2014

New and handy bicycle extension bar for lights. A must for cyclist who desire better management of running cree light wires.

28.1.2014

Hard to get to excited with a type of accessory. When installed this bracket did what I needed is straight and true.

30.8.2015

Works as described. Loosens up sometimes, but I carry a tool with me anyway and can tighten it up quickly.

5.10.2017

Well made and sturdy.I bought this so my Garmin radar tail light head set would be easier to see.
Terms and ConditionsPrivacy Policy